PROBLEM
Build-up of coating on trailing edge of the blanket.
CAUSE
  • Too much pressure between applicator roller and blanket.
  • Blanket packing not trimmed properly.
  • Too much pressure between blanket and impression cylinder.
  • Applicator roller speed faster than blanket surface speed.
  • Dirty blanket.
SOLUTION
  • Adjust blanket from impression.
    KISS CONTACT
  • Packing at least _ inch shorter than sheet length.
  • Applicator roller and blanket surface speeds should be the same.
  • Clean blankets thoroughly.
To Print: Ctrl+P (PC) or Command+P (Mac)